1. Home
  2. ⏣ General Metalworking
  3. Can anyone ID this plasma torch

Can anyone ID this plasma torch

I will greatly appreciate if anyone can ID this plasma torch... A little bit of a gamble on my part...

formatting link
``You are bidding on a slightly used plasma torch with 25 foot leads. The "BRAND" of this plasma torch is unknown, but it was originally ordered for a Miller Spectrum 1250 Plasma Cutter. The torch was used for approximately 1-2 hours, but the machine itself had problems that were not repairable. The torch is being sold in "in working condition", and AS IS.

** Note - the manufacturer of this torch is NOT KNOWN. There are no names on the torch itself. ''

I have not received this torch yet...

i
Reply to
Ignoramus30985
Loading thread data ...

Looks a lot like the Zap Plasmatherm copy of the old Hypertherm 100 amp torch that I got for my old Linde PCM-100 plasma cutter. It didn't work on that machine is the only thing I can say about it.

You paid a lot less than I did.

Reply to
Wayne Cook

Thanks Wayne. I will see what I get when I receive it. Do you recall the specs for it?

i
Reply to
Ignoramus30985

Look for the Max40 and Max 100 torches here.

formatting link

Reply to
Wayne Cook

Thanks Wayne, this is perfect for me, I downloaded and printed that file. Thanks.

i
Reply to
Ignoramus25821

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.