1. Home
  2. ⏣ General Metalworking
  3. Compressor question

Compressor question

I recently picked up a good quality, small, electric compressor used and would like to know how to keep it running well. It is an Emglo AM78. Twin horizontal tanks, oiled pump, 1.5 HP.

Would some one give me a primer on compressor upkeep or point me top a FAQ?

I figure I need to get the tanks drained out and possibly change the oil in the pump.

It will be used to run nail guns and to blow out stuff that I'm cleaning. Is there a cheap filter that I could use to minimize crap going through my air gun when I'm blowing out some thing important?

Thanks,

Jeff Dantzler

Reply to
Jeff Dantzler
Loading thread data ...

Be advised that Emglo has gone out of business, according to a news program (regional PA story) I saw a while ago. The major points of service are clean oil of the proper type, clean intake filter(s), and proper draining.

You may be able to locate an opersting/service manual (and/or spare parts) from a compressor dealer that sold Emglo. They were very popular units in autobody shops and light industrial locations.

WB .............

Reply to
Wild Bill

Thanks.

I think Dewalt swallowed them up.

I will call around to try to source a few spare parts (mainly filters).

Dewalt so far has not gotten back to me on my request for a manual.

I cleaned it up and changed the oil using a detergent free compressor oil this weekend. My neighbor in the building trade said it would last until I decide I want a different compressor. I love how relatively quiet is is.

Cheers--

JLD

Reply to
Jeff Dantzler

DeWalt now offers Emglo, unless they've closed up that line. The local fasteners pro in town still offers new units in various capacities.

LLoyd

Reply to
Lloyd E. Sponenburgh

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.