I have seen the plans on various websites for DIY homemade TIG welders, anyone have any suggestions on how a cutter could be made?
Should't you be able to use the same setup as the TIG but get a cutting torch and compressed air?
Jay
I have seen the plans on various websites for DIY homemade TIG welders, anyone have any suggestions on how a cutter could be made?
Should't you be able to use the same setup as the TIG but get a cutting torch and compressed air?
Jay
No. Much more complicated
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.