Fixed! Tachometer on Clausing VS13 Lathe

Feb 16, 2010 0 Replies

after quite a bit of research, consulting with a friend who's an electronics geek, etc. the tachometer on my Clausing is fixed! The opto sensor and the LCD needed to be replaced, and suitable parts were found at Digikey, but there was still a nasty intermittent problem happening. finally diagnosed it down to a overheating diode in the power supply. works like a champ now.


--Joel


Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required