1. Home
  2. ⏣ General Metalworking
  3. replacing belt on colchester clausing lathe

replacing belt on colchester clausing lathe


Does anyone know the procedure for replacing the main drive belt on a
VS13 Colchester Clausing lathe?
This is the big drive belt that drives the variable speed pulley, not
the two smaller sized v belts that drive the headstock gearbox.
thanks
T.Alan
Reply to
T.Alan Kraus
Loading thread data ...
Clausing should have a manual that explains the procedure.
i
Reply to
Ignoramus11847
No explanation from Clausing, but I finally figured it out , but it took the help of another pair of hands. cheers
Reply to
T.Alan Kraus

Further Reading

  • Clausing Colchester Mod 13 lathe

  • Ive got an opportunity to aquire a Clausing Colchester Mod 13..thesquare topped...

  • clausing-colchester info needed

  • I just picked up a VS-13 clausing colchester lathe.looking for a lube chart,...

  • clausing colchester clutch adjustment

  • Hi, I recently got a used Clausing Colchester 17" lathe (1978) inpretty good...

  • Updated -- PDF manual for Clausing Colchester Master 13 inch lathe

  • Here's a 5 MB PDF file for you Gunner....

  • Colchester Lathe forum

  • The Yahoo Groups Colchester lathe forum was quite busy until a couple or so...

  • Colchester lathe clutch

  • The clutch on my Colchester Triumph 2000 has finally packed up when used in...

  • Clausing Colchester lathe Q's

  • I paid $425 for my 13x36 Clausing Colchester lathe, with sometooling. (good 4...

  • Flat belt on Logan lathe

  • I've finally got my little Loagan Model 200 up and running. Seems to be nice...

  • Any comments on Clausing 6903 Lathe?

  • I'm considering a Clausing 6903 lathe. I know it is a varispeed and thereis...

  • Clausing lathe oil

  • What are the current lubricants to replace the following ones for theClausing...

  • Clausing Lathe Turret

  • I have a Clausing 6913 lathe and have a Enco turret that was designedfor this...

  • Advice needed - replacing variator on lathe

  • I have an Harrison Model AA-10 lathe with a 2HP motor with a dodgyKopp ...

  • colchester student 2500 lathe

  • lathe runs for about 30 mins then starts to slow down within 30 seconds it...

  • Sidney belt lathe

  • This is an appeal for info from Wayne Cook.Wayne, I have a 15"X 96" Sidney belt...

  • Triumph Rocket III - manufacture & testing

  • Monty P. would be proud of this one. *yes*, it has metal content in it. Art Not...
  • « previous thread

  • A short story

  • From the Sand Pit it's freezing here. I'm sitting on hard, cold dirt between...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.