1. Home
  2. ⏣ General Metalworking
  3. Looking for a heat treat oven

Looking for a heat treat oven

I am looking for a heat treat oven for knife making.
If you are in San Francisco Bay Area and have electric or gas furnace you want
to sell
please email me.
Alex
Reply to
Alex
Loading thread data ...

Further Reading

  • Temperature controller for DIY heat treat oven

  • I am getting ready to build Heat treating oven for my O-1 and 440Cknife blades.I...

  • Heat treat oven gloat

  • We just bought a used HT oven for $60. It has about a 1.5 cubic foot interior...

  • Cheap heat-treat oven

  • $70A late 70's or early 80's Blue M oven in good condition. 480 volt...

  • Home made heat treat oven information

  • Anyone have any plans or ideas on making a home made heat treat ovenof say 10 x...

  • Buying a small heat treat oven and Annealing oven

  • I stop in a shop today to look at some tooling, MT drills and reamers, some...

  • heat treat queries

  • I bought a VERY old heat treat oven quite a long while back...I'd like to...

  • Heat Treat Solutions

  • I am interested in heat treat some 6061 Aluminum parts. I was planningon using...

  • heat treat head?

  • Not quite enough information. Ned to know the alloy.For example, if the head is...

  • how to heat treat??

  • I was wondering if some in this n/g knows how to heat treat metal. I did itin...

  • Heat treat/ cold rolled

  • Yesterday I plasma cut some notches in 3 x 1/2 x 4 cold rolled. The pieceswere...

  • TI- Heat treat?

  • messagenews:XNednQcnaLktDmbanZ2dnUVZ snipped-for-privacy@giganews.com...I...

  • Heat Treat oil Material

  • HI guys,I have been lurking around here for awhile reading interesting postsand...

  • Should I heat treat ?

  • If these are replacing rubber bushings I don't see the need to heat treat. ...

  • Re: Heat Treat Foil

  • Never heard of nickle foil... K&G has stainless steel foil for heat treating, I...

  • BSP Thread data

  • Hi i need a data sheet for all BSP threads till 2". i can only find it till 1"...
  • « previous thread

  • homebuilt welding rectifier: single diode instead of bridge rectifier?

  • G'day, Recently I've been given a defect welding inverter for parts. While...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.