Ran into this 6 min. video and personally I wouldn't do this to a vertical mill. Cutting refractory clay and lining up axles to weld.
SW
Ran into this 6 min. video and personally I wouldn't do this to a vertical mill. Cutting refractory clay and lining up axles to weld.
SW
Sunworshipper fired this volley in news: snipped-for-privacy@4ax.com:
'Looked to me like he had it pretty covered up.
It wouldn't be any more hazardous to the equipment than (say) grinding on a lathe. You have to protect the ways and clean up scrupulously after you're done.
LLoyd
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.