OT: (Slightly) Prototyping bezels?

Mar 10, 2005 4 Replies

First reply

JR North

Produce 1 good blank of each bezel in the material duJour and use casting plastic and molds to make the rest. It's easy. You can tint the plastic any color, including silver. Micromark or the local crafts joint have all you need. JR Dweller in the cellar

Read the full reply

Anyone know of a prototyping service that does not cost an arm and both legs? I need bezels and cases for three differnt devices, a very thin switch that fit flush in 3/4" thick walls, a 3x5" panel and a box to hold a pocket remote control . I have machined some basic parts on the mill using stock plastic boxes but that leaves something to be desired in appearance. I only need a dozen or so of each so tooling is out of the question.


When are we going sailing?

x?URÍnÛ0 ¾û)xê.«sèvé?= ??BQèX°Lº"Ç}ú}?,C©ï:?I¦ú7·Ái?æ°?)«NI.4hyîºÑ}y>¶m?âKÎ|[ ?õQçC׿]?D.¦rÞi5>?g:­NQ7-Ê44i??ÑáJ9ML]íïéø¥S¡¥¤ÈF¡0¶ì¾S?XºrßuJ²®ûY?Þm?[Qg?I¯ÿE?0M¢é@PêêûR}?+8??Î ²ê%ª9t?xnrOêãË!½~af¾ØA­0¬?ø?³µÎ H???Îi¸°¹òØwð_¹ìÍæ¤mÉãøO?°òj#üÒÓáÇÃ?h??8??ÎÓíçÿB?KãÐz«¡??qºcX4NìTxF@ð(^4S_m´ÁÌ!Bü?ÎL§`)¹¸?JÍ)g ¹Ý+w??9n? ÔÁ7+?m ²Z¾Tmxgg¶T@aY8? ?û;Ø#hñ?Z³ùd!äjZ§ÈÐZ·®?+*?²??*ôcehQ¹l?¿úd

I used Front Panel Express for the watermaker, fuel management and refrigeration controls and was very happy with the result but this but these bezels are for small membrane switches and a cockpit monitor for the lighting system. They need to be plastic and have some vertical dimension to them.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required