I seem to have to clean the threads on my 4-jaw a lot. Chips stick to them. Could I use them dry and would that lessen the chip problem?
Bob
I seem to have to clean the threads on my 4-jaw a lot. Chips stick to them. Could I use them dry and would that lessen the chip problem?
Bob
I guess that I should have said that I meant the jaw threads, not the spindle threads.
Thanks for all the advice. I solvent cleaned them to get all the grease off and very lightly oiled them. The grease was the original shipping grease that I hadn't removed. I guess I thought that it was supposed to stay. Thanks again, Bob
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.