That damned Tool Farie stikes again

Gunner · 2007-09-12T04:31:32+00:00

When I wasnt looking, someone stuck a nasty old cast iron table with 2drill press thngies mounted on it. in my trailer Both the table andthe drill thingies say Walker-Turner or some such. Each got one ofthose 110vt plugs on em.And while they were at it...they also stuck in something that I dontrecognize. Sorta kinda like a grinder thingy. Name plate says HarigTool Cutter Grinder. WTF? Whats a Harig?And they put all these plastic wrapped thingies...Indexer? In therewith it. There is some sort of accessory thing with an air connectionsticking out of the middle of it..and something with a motor andbelts. The stuff is all oily and shiney inside the plastic. Somethingmust have leaked.And a box of wierd ashtray looking round stone things and some flatround things. But they all got holes in the middle, so they wont holdbutts worth a damn. Might be pretty good RC Cola soda coastersthough....And a flat thingy with lines running across it. When I put my truckkeys down on it..they stuck tighter than a pig. Had to pry em offwith a rope .Would this stuff make good boat anchors? Mighty pretty though...niceshiney paint and stuff. Be a shame to dump em in the creek. Though..they might look pretty good in the front hard, with flowerpots on em.I asked the guy whose shop I wuz working at about em, he claimed henever saw em before..then mumbled something about needing the space.Space is pretty big, aint it?Gunner

Sep 12, 2007 62 Replies

Rate this thread:

cavelamb himself 18 years ago

Well, no green card = illegal alien (shrug)

Vote

Larry Jaques 18 years ago

On Mon, 17 Sep 2007 09:15:46 -0700, with neither quill nor qualm, Gunner Asch quickly quoth:

Guy or gal, huh?

formatting link

until the end. I'm sure you'll bust a gut.

Vote

Gunner Asch 18 years ago

ROFLMAO!!!!!!!!!!!!!

Humm...dont most witches melt when they get wet?

Gunner

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required