I have done some searching without success. Is there a standard TPI for the scroll plate of a chuck?
Was FAQ's-Now metalworking question
Feb 13, 2009
5 Replies
Hi Milo ! The five inch on my Logan looks to be about a quarter inch pitch . New toy ?
One could say that. Peace Milo
formatting link
it out
I doubt it. Why the question?
I was looking at an old beat up lathe chuck. Thought maybe I might try to restore it. Or not.
Peace Milo
formatting link
I don't think so, it is pretty much up to the individual manufacturer.
Can't tell from your picture, but if you can find the manufacturer name on the chuck, you may be able to find a replacement (if that is your goal). If the chuck is a Bison, we can help with parts.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required