Something less than 1" in width, about 1/4" in thickness, flat one side, convex the other.
Want it to put it on a panel as a rub strip.
Something less than 1" in width, about 1/4" in thickness, flat one side, convex the other.
Want it to put it on a panel as a rub strip.
On 7/3/2018 6:46 PM, unk wrote: > Something less than 1" in width, about 1/4" in thickness, flat one side, > convex the other. > > Want it to put it on a panel as a rub strip. > Its an extrusion. Maybe surf the aluminum extrusions on McMaster Carr?
I know they have half round,
Yours sounds like a larger radius.
Scroll down third from the bottom. 3/16 is the thickest though.
Rub rail.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.