⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30777 Threads Posts
to

Worth reading in ⏣ General Metalworking

Aberdeen Scotland Visit: Metalworking Stuff?

I'm off tomorrow for a week in Aberdeen visiting my sister and BIL. Top on my list is to do some of the local distiller...
6 comments posted 18yrs
posted by keillorp135
6 comments posted 18yrs posted by keillorp135

Brass Discoloration

Ok, so I am an idiot. I pushed things too far and may have cost myself a bit of money in the process. I work with beer...
13 comments posted 18yrs
posted by edramshaw
13 comments posted 18yrs posted by edramshaw

My dumb question of the month

I need an hour meter and a low RPM tach for my SA 200 welder. The operating range for the tach would be 2500 rpm max. I...
8 comments posted 18yrs
posted by toquerville,utah
8 comments posted 18yrs posted by toquerville,utah

Wood Cedar

Wood Cedar - Compare Prices at NexTag Compare and find bargain prices for over one-million home and garden products at...
0 comments posted 18yrs
posted by shenlishu520
0 comments posted 18yrs posted by shenlishu520

Ping: Iggy

Hey Iggy, I am in the process of converting my buzzbox to something resembling a 150A TIG supply. I already have the AC...
11 comments posted 18yrs
posted by jonREMOVETHISdanniken
11 comments posted 18yrs posted by jonREMOVETHISdanniken

Makers Faire?

--Anyone going? I'll be the guy with the steamboat; come say hi if you're in the neighborhood..
0 comments posted 18yrs
posted by steamer
0 comments posted 18yrs posted by steamer

Mig welding

I am a newbie and have been reading about when arc weldign sometiems you lay a center bead, then stringer beads beside t...
4 comments posted 18yrs
posted by stryped
4 comments posted 18yrs posted by stryped

Punch blanks

Brought home a few punch blanks, or raw materials, which are little round things the size of various rifle cartridges....
8 comments posted 18yrs
posted by ignoramus30765
8 comments posted 18yrs posted by ignoramus30765

Dead die

I have been using a Mastercraft 6-32 die to cut thread on a 1/8 welding rod to use (a small section of) as a gnomon for...
12 comments posted 18yrs
posted by mkoblic
12 comments posted 18yrs posted by mkoblic

Clausing 5914 chatter -- update 2

Well, I measured the dovetails on the cross-slide, and they seem pretty good, no more than a thousandth of wear on the...
4 comments posted 18yrs
posted by joegwinn
4 comments posted 18yrs posted by joegwinn

Lincoln Tig 300 problems

I picked up a Lincoln tig 300 square wave machine a couple weeks ago. Code 9298-ff The guy claimed that the power could...
18 comments posted 18yrs
posted by gunner
18 comments posted 18yrs posted by gunner

Reall good

http://infostore.org/user/-Zinya%20Shinoda-
0 comments posted 18yrs
posted by hyimiona
0 comments posted 18yrs posted by hyimiona

FS: Raycon sinker EDM

I have a chance to buy a CNC sinker EDM. I don't need two, so my Raycon will be surplus to my needs. The biggest featur...
0 comments posted 18yrs
posted by karltownsend.NOT
0 comments posted 18yrs posted by karltownsend.NOT