Would rs shielded bearings instead of zz be alright in gearbox of large angle grinder. I think they should be as I think rs sealed is rated 240 degrees fahreheit
- posted
9 years ago
Would rs shielded bearings instead of zz be alright in gearbox of large angle grinder. I think they should be as I think rs sealed is rated 240 degrees fahreheit
Should be fine on the output shaft but motor shaft might be a bit fast - check speed ratings if you are changing the motor ones.
Bob
It is the small bearing on the output.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.