How much would it cost to get made something similar to the chuck shown in the link below? This chuck is some form of uncommon autolock type, I'd like one made that would accept int30 tools. Any ideas?
Bob
formatting link
Getting a new collet chuck made
May 09, 2007
1 Replies
It looks suspiciously to me as though they may have adpted a spindle design intended for 'push' type collets. as used on capstan lathes and the like. If so you may be able to make a spindle cap and use standard collets so as to at least get some use out of it, if you can identify the type. I don't suppose you'll be that lucky, though.
Is your existing chuck the 'very small' Autolock (now extinct), or some weird hybrid?
HTH
Tim
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required