hi all
i'm new to this group , one of my oilers (ml7) broke where th drip hole is . ive bodged it with a sleeve as a temp job. i can identify either of the threads (headstock and oiler body) it was broke moving the m/c and im assuming im not the only one ! so anybody coul tell me the threads id appreciate i
-- willowkevi
----------------------------------------------------------------------- willowkevin's Profile:
!/8" gas threads
-- Regards,
John Stevenson Nottingham, England.
hi
is that the headstock tapped hole or the male on the oiler body(whic the part with the two hexagons and sighting hole screws to ? mine ar diff diameters and pitche
-- willowkevi
----------------------------------------------------------------------- willowkevin's Profile:
The oilier thread into the headstock is 3/8 Gas (27TPI).
Steve
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.