inner diameter tube polyurethane coating

hello! i would like to get some advice on what type of resin should i choose.
i want to make a resin coating on the inner diameter of a tube. The way the
coating will be made is the following. Firstly, i will put in the tube a large
quantity of resin and then i will push a ball throughout the tube. the ball
should have a 4mm-smaller diameter from the ID of the tube so a thin film of
resin to be formed.
do you have any suggestions on what type of resin or specific which exactly
product should i use?
Reply to
aristotelis
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.