Configuration in wildfire

: "Danny S." wrote : I new in wildfire1 : How can I change the default dimension to Nominal?

Tools>Options, set Tolerance_mode to Nominal (it defaults to Limits). Also, at the bottom of the Options screen you'll see a Find button. Press that and type tolerance on the input line. Also, check the box that says 'Search descriptions'. This will show you the several options controlling selection and display of tolerance. Likewise, get used to using the Help function which contains a lot of information about using and configuring the software. BTW, drawing mode has its own set of options. 'File>Properties>Drawing Options' takes you to them. Tolerancing is separately configurable for drawings.

: How to switch between mm and Inch?

Didn't you like the answers we gave you when you asked this same question a week ago? You did read them, didn't you? I hate to think that you ask questions then don't pay any attention to the answers your fellow users generously provide. Go to this newsgroup archive on Google and do a search on "units", tons of material there on this question and the answer hasn't changed in the six years I've been using this software.

David Janes