Hi, I'm trying to make a flat harness with multiple wires attached to multiple entry ports of a connector. I'm following the steps on "Suggested Technique for fanning out flattened wires to connectors" (by
formatting link
but when I select Fan Out the wires remain out of the connector, and the message "Some wire/cable(s) were not fanned out due to insufficient length." appears . I selected the shortest wire and I even used the Assemble All command to attach each connector to the shortest wire automatically? but it don't work!! When I made a mistake? Does anyone have any advice on fanning out wires? Thanks and sorry for my English! Ciao Pino from Italy.