Hello
What is the best way to export files from Proe to UG?
My parts are small injection moulded plastic parts so they have lots of small rounds.
Thanks
Hello
What is the best way to export files from Proe to UG?
My parts are small injection moulded plastic parts so they have lots of small rounds.
Thanks
the ttf project reviewer may read proe and write ug
Thomas
Depends on what version of Pro/E. In 2001, STEP will give UG a solid model. In Wildfire, try the hidden config.pro setting to allow Parasolid exports.
Thanks very much Petteri
petteri wrote:
The following settings are recommended up to Pro/ENGINEER Wildfire and Unigraphics NX 1.0.1.2.
"petteri" ÓÏÏÂÝÉÌ/ÓÏÏÂÝÉÌÁ × ÎÏ×ÏÓÔÑÈ ÓÌÅÄÕÀÝÅÅ: news:bm2s8t$b88$ snipped-for-privacy@phys-news1.kolumbus.fi...
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.