Hi all Back again I have taken your advise from before and managed to get hold of a USBmod2 usb parallel interface, i have set up circuit of leds as per example
i have seen at but for some reason i can not seem to control it. the device is set up on Com3 as shown
All I want to do is simple relay switching at the moment.
Any ideas would be very welcome,
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
Add image file
Upload is a website by engineers for engineers. It is not affiliated with any of manufacturers or vendors discussed here. All logos and trade names are the property of their respective owners.