Expanding Foam Question

If you're foaming the inside of a body tube & notice a void (a missed spot inside left unfoamed), is it OK to drill a hole in the BT to pour in a little more where needed? -- Richard "I can faintly smell that Krylon from the other room" Hickok

Reply to
Loading thread data ...

This should be in the FAQ!

Joel. phx

I've been know to mess up a thing or two that was 'nearly' perfect,...

Reply to
Joel Corwith

The act of trying to make a really nice paint job is an absolute Murphy's Law Target for that sort of thing... the more you sand the primer, the more even your color coats, the more likely you are to try to finish it off with a nice glossy clear coat... and then get a fingerprint or something in _that_!

-dave w

Reply to
David Weinshenker

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.