Hi everyone,

I have an project to do about cork screw.I was trying to finish the mates needed but I got stuck with the mates between Handle and Arms.I have to show the total motion of the Cork, too. Is anybody which can help me with this?

Thanks a lot, I will apreciate,


Reply to
Loading thread data ...

You should read up on "Advanced Mates" a Gear or a Cam Mate will probably do what you require.

John Layne

formatting link

Reply to
John Layne

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.