Hello everyone,
I'm in a bit of a pickle,
I need to create rips and bends in a non planar surface(ie curved surface) can this even be done?
TIA
PMP
Hello everyone,
I'm in a bit of a pickle,
I need to create rips and bends in a non planar surface(ie curved surface) can this even be done?
TIA
PMP
"PMP" wrote in news:y7dUa.1924$ snipped-for-privacy@news1.mts.net:
No, you can't create a Rip feature using a non-linear edge. When selecting edges to rip, there's a little pink tooltip that comes up to tell you to pick an "interior, linear edge"
You can, however, create a cut that works like a rip like this:
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.