Custom Properties linking to filename.

Hi:
There was a thread regarding this subject back in May. I tried to reply
to it but couldn't get it to work.
Here is a link to the original thread:
formatting link

I would like to try the macro feature method, but I can't seem to figure
out how to copy/paste the code and make it work in my part files.
Can anyone help with this?
I'm open to a good how-to or sample part file.
Also, could this method work for assemblies as well? Macro "feature"
seems to indicate that it won't, but .....
Thanks guys.
Todd
Reply to
Todd Brake
Loading thread data ...
Todd,
I gave up on this issue back on 05-06-03 when I first started that thread. I just played with it again and found that if you set $PRP:"SW-File Name" as the custom property value, it will actually add the filename. I don't think it used to do this when I asked the question back in SW03. But it does now (SW04 SP3.0). I also did a "Save-As" a new filename and it updated properly.
Now, if I can just remember why I needed to do this way back then, this may be useful....
Reply to
Seth Renigar

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.