Design Table Reference

I am not spam wrote in news:1191935396.453618.41580 @o80g2000hse.googlegroups.com:

Design tables cannot connect to, or be connected to by SW documents they are not a part of. They can make references to other Excel documents, which requires all of the involved design tables to be saved separately from the model documents.

If I misread you and you are wanting to reference another part's design table cell from an equation in the part (not in a design table), that can't be done. The closest you can get is to have the target design table driving a dimension in its model, then reference that dimension in the equation you are adding to the other model. This will require both models to be in an assembly.

Clear as mud?