Draft Question

If I extrude a rectangle and put a 10 degree draft on it. It will put the draft on 4 of the sides.

Is there anyway of selecting which sides to put the draft on?

I want a draft on 2 opposing sides not all 4.

Cheers

Reply to
J Parr
Loading thread data ...

Extruse it straight, and then add a draft feature. This allows you to select the specific faces to draft.

Dave

J Parr wrote:

Reply to
Dave Nay

If I extrude a rectangle and put a 10 degree draft on it. It will put the draft on 4 of the sides.

Is there anyway of selecting which sides to put the draft on?

I want a draft on 2 opposing sides not all 4.

Cheers

Reply to
J Parr

You question was answered already by Dave...

Extrude it straight, then insert the draft feature (separate icon/feature) and select the two sides you want....

Scott

Reply to
IYM

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.