Hole Wizard flips direction on curved surface

I am using (in 2006SP4.1) a Hole Wizard to create 6 CSK M5 holes on a slightly bent plate (Slightly means less than 5 degrees bend across the length of the plate). The points that define the hole locations are constrained on the same surface.

4 out of 6 holes come out OK, but two holes are flipped, the hole cut extends out from the surface of the plate into thin air, rather than into to plate.

I can't figure how to flip these???

Reply to
Chebeba
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.