quick question?

Hi Zander

Yes it was and I just tried it. It works like You say in both SW 2005 and SW 2006...in SW 2004Sp05 i can drag the endpoints

Krister_L

Zander skrev:

hmm, I didn't think it was that long since I tried to do that. I most always want to extend the length of the offset - especially when it's to the inside etc.

Me neither....could have been changed in some of the Sp's in SW05...I only have the latest installed

Is the offset geometry a spline? Splines don't drag very well.

Roland

I'm not sure but I think this happened/changed in a 2005 service pack. To get around it draw an extra line and extend or trim the offset line to it. Delete the work line, then you are free to drag the endpoint of the offset geometry where you want while keeping the offset relation.

PITA, but it's a work around.

Rory

Roland wrote:

Zander,

I just tried using an Intersection Curve which created a line an arc and a spline. The Line - No problem The Arc - No problem The Spline - Slight problem, couldn't drag the endpoint intitally but then I created a line to entend to and Extended the spine and it seemed to work fine after that. Funny thing though, I could drag the spline endppoint anywhere EXCEPT beyond the point where I first extended the spline to. Does that make sense?

HTH, Muggs SW 2006 SP2 EV, but I'm sure it worked that way in SP1 as well Win XP Pro SP2

Yes. The spline knows what it looks like anywhere up to its endpoint - past the endpoint it has no definition (does it curl left, does it curl right... who knows? Do you really want SWx to guess? Does it ever go well when SWx makes guess?)

Ed, You're right of course, so NO I don't want SW to guess at anything. But the spline created was an "arc" so I would expect it to stay fair as I drag it.

Muggs

There are definately many different cases - some working some not. My particular situation is an arc created by intersection with a face, then trimmed to 2 lines. Afterwards I offset this arc segment and I expect to be able to pull out the endpoints of the offset arc to lengthen it but it wont budge.

Zander

It appears that this "change" happened around the same time the trim tool went "super" on us.

If you use the trim tool with the "power trim option" it allows you to click somewhere near the end you want to extend then select how far out you want it to go. You can click in space to extend or click on another entity to extend to.

Cadguru