Re: How Does Your CADCAM System Handle Real World Simulation Tasks?

While losers who can't back up what they have to say continue to post

> complete and utter bullshit and spin consider that the Jon Banquer > blog can always back it up with FACTS! >

"FACTS"? Like the FACT that your "problem" with mask on arc was completely self inflicted?

The FACT that you signed up a fake name on emastercam so you could complain about Mastercam's inability to machine an open pocket, only to be quickly rebuffed by people who actually know what they are doing?

The FACT is that you are utterly helpless on virtually every aspect of Mastercam.

If you spent 1/10th the time using and learning the software, as you do complaining about it, you wouldn't have nearly so many complaints. Then again, you are not even remotely sane, so who knows what would happen.

Reply to
Joe788
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.