Re: Non-perpendicular extrusion

Howdy,

>
> Does anybody know if and how you can extrude a sketch at an angle other than
> 90 deg to the sketch plane?
>
> Thanks
>
> Jon

how about this one-line answer? loft. :~)>

"p.s. bob z. is getting lazy on this beautiful Friday afternoon in the Midwest"

does bob z.'s boss ever read these things?..... : )

heck no! good thing, too! :~)>

Wait 2 months = SWX 2004 = not a pain in the ass

Mike

Or sweep (especially if there's an edge somewhere parallel to the direction you want to "extrude" in- remember that the path can be miles away- it doesn't have to pass through a sketch vertex) If the edge you want to use as a path doesn't end at the sketch plane, open a (3D if easier) sketch, convert the edge to the sketch, then drag the endpoint of the "on edge" line to break the temporary relation, (works in 3D just as for a 2D sketch), and make the endpoint coincident with the sketch plane.