I am trying to make a cut line pattern for some stainless steel tubing.
I probably should have started out with sheet metal folded into a circle, but instead I extruded my tubes, then cut-swept one from the other. It worked great, except now I want to slice down one side of a tube, then flatten it out. I hope to print it out, or at least get measurements that I can transfer to the actual tube for my cut line.
Any suggestions?
yup well do your slice and pick an outer straight edge and hit the insert bend icon to create a sheetmetal part, flatten and there it is in all its squashed glory. make a drawing using named view - pick flat pattern from the list
Make sure you do a "cut revolve" this will ensure your sucess in unfolding this
Ben
Amazing. Works just like you said.
Wish I had used something like this years ago.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required