SW2008 ft-in format

We have one person now using SW2008 and his drawing dims are coming in as

3'2 1/16". Notice that there is no dash after the 3' as in 3'-2 1/16". Does anyone know how to make this happen? In reading the Help file, it looks like the dash is the SW standard and if you have an imported drawing that doesn't have them, you can convert it to put them in, but not remove them. So it appears to be a bug that we don't have them, but I wanted to ask before crying wolf.

WT

Reply to
Wayne Tiffany
Loading thread data ...

Wayne,

I am pretty sure this is a bug. Rob Rodriguez was talking about this over on Eng-Tips I believe. I would pester SW about it.... :-)

Cheers,

Anna

Reply to
Anna Wood

It is a confirmed bug and not fixed in SP1. We can't move to 2008 until this is resolved.

Rob

Reply to
robrrodriguez

Ok, thanks. Hmmm, could be a problem for the shop.

WT

Reply to
Wayne Tiffany

SPR # 404393

WT

Reply to
Wayne Tiffany

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.