Wrap Text/Cut around radial surface - Help ?

I have a radial/ conical surface on which I need to cut some text. This text needs to be "wrapped" around this radial surface. If anyone could give me advice/suggestions as to the best way to accomplish this, I would greatly appreciate it.

Thanks in advance, Sean

Reply to
SeanMc
Loading thread data ...

Reply to
G. De Angelis

Thank you - I figured out how to use the wrap feature - simple enough once I realized it was even there. Only problem was - because I was projecting onto a conical rather than cylindrical surface, and my logo (supplied by an outside source) was drawn on straight lines, my projection ended up having a smiling curvature to it. Is there a way to avoid this, or does it come down to playing with my sketch (pain in the ass work!) to compensate.

Thanks again - Sean

Reply to
SeanMc

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.