Those prices seem pretty reasonable. As for the US belt, is it anti-static/oil & heat resistant? You can get standard belts alot cheaper, but if they last a few hours on a lawnmower they've done well.
-- snipped-for-privacy@btopenworld.com Change dot to reply
> OT but where else I wonder!:-
>
> Does anyone know a good source of A section V belts for my latest project
> which was the resurrection of a 1985 WheelHorse garden tractor/mower.
> This uses 3 belts, one to drive the tractor, one from PTO to mower , & one
> to link the three cutting heads together on the mower. The PTO belt is
> simple - its only 40" so I got it from a motor factors. The mower belt is
> 79-80" long & cost £24 from Fenner transmissions!! Now unfortunately I've
> just bust the main drive belt (can't complain I WAS cutting up a steep hil
> & I am 19 stone!) which is 88" long . Nearest belt I had was just too long
> so looks another £25 worth. However I noticed on an Ameican motor
> factor's website, an A88" belt was only $12.47, so they must surely be
> available somewhere in UK at sensible prices? Any ideas? Or does anyone
> have an A88" (2220mm) belt lying about they'd sell for sensible money?
> --------------------------------------------------------------------------
---------------------------
snipped-for-privacy@cwcom.net John Lloyd - Cymru/Wales
>
> --------------------------------------------------------------------------
---------------------------
>