Battery on the ground

"SteveB" fired this volley in news:ddaab5- snipped-for-privacy@news.infowest.com:

If the ground or concrete is cold enough to freeze it, yes. Otherwise, that's just an old wive's tale.

LLoyd

Reply to
Lloyd E. Sponenburgh
Loading thread data ...

Steve,

If the battery is dirty, then that will cause a drain of the battery's charge. Place the battery on a wooden board or coke case.

Besides, how long do you plan leaving the battery on the gound?

W. Kirk Crawford Tularosa, New Mexico

Reply to
W. Kirk Crawford

Lloyd E. Sponenburgh wrote in article ...

It was actually true of the old hard-rubber cased batteries.

Electrons WOULD leak through the porous case to ground - eventually discharging the battery.

It is NOT true of today's batteries.

Reply to
*

"W. Kirk Crawford" wrote: If the battery is dirty, then that will cause a drain of the battery's charge. Place the battery on a wooden board or coke case. ^^^^^^^^^^^^^^^^^^^^^^ If the battery has enough dirt on the outside to conduct electricity, the drain will take place across the top. Setting it on a board or coke case will have no effect. The bottom of the battery could be in contact with a copper stake driven into the earth with no effect. It's not in the circuit.

Reply to
Leo Lichtman

I have heard that if you sit a battery on the ground or concrete that it will lose its charge faster. Is this true?

Steve

Reply to
SteveB

Yes, in the Winter. Doesn't have to be cold enough to freeze, just cold enough to get stratified layers of acid concentration in there.

Reply to
Andy Dingley

You ARE joking, right? Martin

Reply to
Martin Whybrow

Are you *'s alter-ego? Martin

Reply to
Martin Whybrow

"Martin Whybrow" wrote in news:CSzEj.818 $ snipped-for-privacy@newsfe6-win.ntli.net:

No.

Reply to
RAM³

"Martin Whybrow" wrote in news:h3AEj.825 $ snipped-for-privacy@newsfe6-win.ntli.net:

No.

Reply to
RAM³

Like some other things I have heard over many, many years I believe this has evolved. I think the rule to not place storage batteries directly on the concrete but on wood instead was because the leaked acid would severely damage the floor. I don't think it originally had anything to do with the batteries discharging. If someone saw a dead battery sitting on concrete with a batch of corrosion all over the bottom, it was easy to believe the concrete had caused the battery to go dead.

Don Young

Reply to
Don Young

I'm sixty, and learn stuff every day. I love it. All my life, I've believed this. Always sat my batteries on a piece of 2 x 6 on concrete. Good, one less thing to do.

Steve

Reply to
SteveB

attery on the ground or concrete that it

always seen this story; the only thing I could think of is that damp concrete definitely exudes some sort of alkali vapor; leave a piece of aluminum in a damp garage all winter and see all the crud it accumulates. maybe that neutralizes the acid in the battery, although if it's in the air i don't see what good a piece of plywood would do unless it was wide enough that the battery was in its own microclimate.

Reply to
z

I'm in the same age bracket as Steve and believe in the acid separating from the water in strata due to chilling it. Ionic flow must take place for battery operation to take place. Without the acid mixed in evenly, only small areas of the plates can conduct electrons. If only 5% is available, the effective resistance is excessive and makes it look dead.

Martin

Mart>>> I have heard that if you sit a battery on the ground or concrete that it

----== Posted via Pronews.Com - Unlimited-Unrestricted-Secure Usenet News==----

formatting link
The #1 Newsgroup Service in the World! >100,000 Newsgroups

---= - Total Privacy via Encryption =---

Reply to
Martin H. Eastburn

A good place to get reliable information on leads acid batteries can be found at:

formatting link
question you have is addressed under "battery myths", there is also excellent info on battery safety practices on the same site. It is kept up to date to address changes in technology, at least thus far anyway. regards, Joe.

Reply to
Joe Brophy

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.