I'll bet this has been asked zillions of times but not by me.
I need to cut some drill stem (very appx. 2.875) in order to weld it to larger pipe of ROUGHLY the same or closely bigger dimensions?
I don't want to do this but 5 times.
Thank you.
I'll bet this has been asked zillions of times but not by me.
I need to cut some drill stem (very appx. 2.875) in order to weld it to larger pipe of ROUGHLY the same or closely bigger dimensions?
I don't want to do this but 5 times.
Thank you.
You might want to check out this little program - tubemiter.exe located here along with instructions:
click on freeware at the top and scroll down to it:
bc12 snipped-for-privacy@hotmail.com wrote in news: snipped-for-privacy@j73g2000cwa.googlegroups.com:
You can also use WINMITER at:
Okay, guys. I got the information and that is just what I wanted.
Thank you.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.