What Ernie won't tell you

Super secret level 7 acquired by only a select few, exposed for the first time here.

Start with level 4; then add standing on your head blindfolded!!

Think, "use the force Luke!"

Okay but seriously folks, that's sounds like a good technique Ernie, no disrespect ment.

Richard

>Here is an exercise to practice when not welding.

Level 1

Take a 3/8" steel washer. Place it on a piece of white paper. Take a nice sharp pencil. Place the tip of the pencil against the paper inside the washer. Now start swirling the pencil tip around the inside of the washer to draw a circle on the paper. Keep circling the inside of the washer, while nudging the washer across the paper. Try to end up with the washer traveling in a straight line across the paper. You should end up with a long swirl pattern acrosss the page. Keep parcticing until the swirl pattern is even and in a straight line.

Level 2

Same setup, with one change. Once again slide the washer across the page while swirling the pencil tip around the inside of the washer, but now DON"T touch the paper with the pencil tip. This means being able to hold the tip of the pencil within a 1/16" of the paper without touching it and without lifting out of the washer.

Level 3

Do Level 2 while standing next to the table without any part of your arm resting on the table.

Level 4

Move to a 1/4" washer.

Reply to
AMW
Loading thread data ...

[snip]
[snip]

Wax on. Wax off. Wax on. Wax off....;-)

Reply to
mb

When you can snatch the pebble from my hand, it will be time for you to leave...

Reply to
Jon Ward

Wouldn't that be tungsten, not pebble?

Reply to
Ernie Leimkuhler

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.