Latex Paint Recommendations

I use Behr latex and 'seal coat' it with Minwax water based polyurethane (3 coats) and get resistance to 10% nitro. I have NOT tried it on fabric yet, but will this summer. I thin with water and add a couple drops of soap for spraying. There was an article a year or two ago in MAN that has all the info you are looking for.

Good luck.

Jim Branaum AMA 1428

Six_O'clock_High Target snipped-for-privacy@Guns.com

I sprayed my 1/3 scale Fly Baby Biplane covered with Coverite with regular white for primer then the color(s). I used Bear brand Latex Enamel and works OK...Gas does not seem to harm it, although it still feels 'soft'. I should have painted some type of clear over it as the black from the exhaust is discoloring it some.... and where I handle it the most (Vertical fin) the color is smudging/coming off.....

Here is the link to the MAN article:

I covered cloth with Behr latex, thin with water and used latex flotrol (some say soap or windshield fluid doe sthe same). Sprayed great.

Clear coat with Nelson hobbies clear.

Hard as a rock, no problem, using gas

Mike

"Bruce M." wrote:

On 2/17/2004 11:31 PM Ted shuffled out of his cave and grunted these great (and sometimes not so great) words of knowledge:

I usually use a flat latex - the brand doesn't seem to matter at all (I have used various brands).

I would suggest using a primer. It isn't really necessary for fabric though. If you do use a primer, I would suggest a "High Build" automotive primer applied LIGHTLY. When dry LIGHTLY sand with 320 or

For thinning I use about 1 1/2 oz of "Flotrol" per quart and windshield washer solution (do not use window washer solution if the paint is white

- it will make a SLIGHTLY noticeable tint in white paint). For white, I use regular water with about 2 drops of liquid soap added. Start with a

Using gas you will not need to clear coat it. Remember that latex takes about 30 - 45 days to fully cure (depending on temperature and humidity)