creating linetypes without the long piece at the end.

Have created new linetypes for a drawing but am getting the extra long
section at each end of the line and at corners. Have toggled settings
and commands such as ltscale, plinegen, on and off as well as enabling
and disabling plinegen in the properties dialogue box. Is there a way
of writing a linetype to avoid long pieces at the start and end?
Scott
Reply to
sw
Loading thread data ...
No.
Reply to
Paul Turvill

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.