1. Home
  2. AutoCAD discussions
  3. intersection blips

intersection blips

i have blipmode set to off, and on this particular file when i use an
intersection as a temporary tracking point the intersetion icon is left to
exist.
regening doesn't remove blip
can't select it like entity
doesn't delete after entities it was used for is deleted.
auggestions on removal?
Reply to
Adam B
Loading thread data ...
Sounds like a video driver issue.
Reply to
Huw

Further Reading

  • looking for particular set

  • All,have a look at these building blocks :...

  • I found this set !

  • Hello,I found this set on eBay. This model was madefor a...

  • Intersection

  • HiI 'am looking for a lisp routine which can indicate the intersection of...

  • Questions about an HO set I have

  • I received a Walthers "Trainline" Deluxe HO Railroad Set as a giftback in 1995....

  • Am I a fool to buy this mill/drill?

  • Take a single parallel and lay it down on the clean bed of thevise, so your 3"...

  • kinda off topic - anyone remember this particular model train transformer?

  • it is metal...and it is working.... so it's more on topic than the political...

  • I hate it when I do this!

  • Today, I went to Vegas, and while there, picked up the unique carport stitcher...

  • Sheldon Lathe

  • I have to find which cabinet / desk I have my Sheldon documents. I have a L-44 a...

  • Line Intersection

  • HiI 'am looking for a lisp routine which can indicate the intersection of...

  • To Clean or Not to Clean when TIG Welding

  • I'm taking a TIG welding class which is: Watch 4 videos on TIGwelding and...

  • Do I have 208 or 240 volts in my apartment?

  • I just had a new circuit installed for a dryer. I was told it was 240 volt but...

  • Transfer intersection to a sketch entity

  • Hi,Perhaps an easy question to answer.I have a surface which intersects the...

  • Can i have dims in drawing file control dims in part file

  • Can i have the dims in the 2d drawing files control the dims in my 3d partfile....

  • ON/OFF/Brake lever does not wsork on the Clausing

  • Happens a lot. Clueless repair is the #1 source of great stuff forcheap that...

  • Forklift hydraulics only works when I step on gas? WTF?

  • I have one forklift (Cat TC60C). The forklift drives and works in general....

  • scale

  • How do people manage scale(s) in AutoCAD? Let me clarify my question. Dimensions...
  • « previous thread

  • trim

  • is it possible (without going into refedit) to use a block as a trim boundry...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.