Looking at new Cam software. Doing mostly 2.5 axis, 4 and 5 axis static/positioning parts along with some
3 axis. 80% 2.5,4,5 axis 20% 3 axisOpinions needed.
GibbsCAM
Esprit
SurfCAM
Thanks
Looking at new Cam software. Doing mostly 2.5 axis, 4 and 5 axis static/positioning parts along with some
3 axis. 80% 2.5,4,5 axis 20% 3 axisOpinions needed.
GibbsCAM
Esprit
SurfCAM
Thanks
[You might also take a look at VisualMill 5.0. It does all that and more, and costs less than the alternatives you list above.]
Best Regards;
Andrew Werby
You might try posting here also..a little less "wild west" atmosphere there:
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.