Wanted: Information on Mastercam 9 PST files

Does anybody have any reference materials on the programming language used in Mastercam 9 .PST files? Thanks!

Reply to
Hugh Jardon
Loading thread data ...

I would like to have a look at it.... The email I use for this message is valid. snipped-for-privacy@spamgourmet.com

Reply to
sittingduck

damn, my spamgourmet account was full... You can upload via ftp to here:

ftp://quakefour.net/incoming Just drag and drop them there with IE, or use an ftp client.

Thanks!

Reply to
sittingduck

Nah, it's working, but I only got one of the 4 files.....

>
Reply to
Hugh Jardon

Ok, all set. snipped-for-privacy@rock.com Once again, many thanks!

Reply to
Hugh Jardon

Easiest to shave all the hair off one side of your balls, then set the other side on fire...stab with an icepick when it runs towards the clearing....

Reply to
PrecisionMachinisT

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.