Gas engine air compressor built on a wheeled tank

Nov 21, 2026 Last reply: 2 hours ago 4 Replies
Jump to replies (4)

Most shop compressors hang off a wall outlet, and that is exactly the habit this build breaks. Wiring in the maker's shop struggles when several machines run at once. Instead of leaning harder on that supply, Workshop From Scratch put a gas engine on a pump, a machine that tops up the air on demand and keeps going with no electricity at all.



The base is a 150 liter, 40 gallon black cylindrical air tank. The factory top bracket came off and the welds were ground flush, then steel round bar axles were welded across the lower legs for four pneumatic tires on split rims. A plasma-cut plate with slotted holes and access ports was bent 90 degrees into a deck, leveled with a digital angle gauge, and welded down. Plumbing includes a Teflon-taped ball valve drain in the lower side port, a brass check valve in a welded top bung, a corrugated discharge line with brass fittings, and a multi-port manifold with a dial gauge, dual quick-connect couplers and a shutoff valve. A high-flow ball valve with a quick-connect sits in the tank's end port.



On the drive side there is a 420cc gasoline engine with electric start and a battery charging coil, an 80 mm centrifugal clutch on the keyed shaft, a dual V-belt pulley and tubular spacer held by a central bolt, and a belt down to the pump's spoked flywheel pulley. That turns the dual-cylinder 2090 pump at about 940 RPM, rated near 500 to 600 L/min. A 12V solenoid with 3 kg of pull works the throttle, and a standard 400V three-phase pressure switch handles control.



The clear trade-off is the pump itself. A 3090 was planned first, but the maker feared the centrifugal clutch would slip under heavy load, and the 2090 went on instead. A smaller 200cc engine had already struggled with pumps of similar cylinder size, which is why the 420cc engine made the cut. As a final test, the finished rig was tipped onto its four wheels and rolled across the shop floor.



Project by Workshop From Scratch. Watch it on their YouTube channel:

formatting link


Going with the 80 mm centrifugal clutch and a belt rather than a rigid coupling seems like the smart part of this build. It does come at a cost, though: the maker worried the clutch could slip under heavy load, and that concern is what downgraded the pump from the 3090 to the 2090. The welded screw-driven tensioning block behind an engine foot is a tidy answer to keeping that belt tight.

I am curious about the pressure side of the controls. A standard 400V three-phase pressure switch is normally a mains device, so how did the maker wire it into a 12V solenoid throttle on a gas engine? Did the switch contacts simply interrupt power to the solenoid, or is there more to it?

The maker has not explained the wiring. What has been shown is that the switch was test-fitted on top of the distribution manifold, and that throttle control runs through a 12V linear solenoid with 3 kg of pulling force. Anything beyond that has not been said.

One variation worth trying: revisit the 3090 pump that was originally planned, now paired with a larger clutch so slip is less of a worry. That would recover the output the current setup leaves on the table while keeping the same engine, belt drive and tensioning arrangement, and it would still roll around the shop on the same tank.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required