I've come up empty googling for this kind of seal.
I need one 1 1/16 x 13/16 x 1/8
Any suggestions on where to look? Long link to what it looks like along with smaller link below.
formatting link
formatting link
Thanks,Wes S
1 1/16 square section lip seal source needed
Jul 26, 2007
2 Replies
formatting link
Is this for a hydraulic cylinder?
formatting link
>
It is for the master cylinder on a Clausing 6903 lathe equiped with a varidrive. McMaster told me that it is a 5 week+ item as in don't hold your breath unless you need quantities.
I guess I'll try applied technologies after I find some adult lubricant :(
Wes S
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required