colchester student 2500 lathe

lathe runs for about 30 mins then starts to slow down within 30 seconds it stops as though a brake has been put on , leave it for 20 mins then its ok again until
the next 30 mins very frustrating
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
lathe runs for about 30 mins then starts to slow down within 30 seconds it stops as though a brake has been put on , leave it for 20 mins then its ok again until the next 30 mins very frustrating
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
On Wed, 17 Feb 2021 22:18:02 +0000, ian

The spindle bearing (tapered bushing) hasn't been properly lubricated / maintained and it is hot seizing.
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
On 17/02/2021 22:18, ian wrote:


Single phase or three phase?
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload

Polytechforum.com is a website by engineers for engineers. It is not affiliated with any of manufacturers or vendors discussed here. All logos and trade names are the property of their respective owners.