lathe runs for about 30 mins then starts to slow down within 30 seconds it stops as though a brake has been put on , leave it for 20 mins then its ok again until the next 30 mins very frustrating
- posted
2 years ago
lathe runs for about 30 mins then starts to slow down within 30 seconds it stops as though a brake has been put on , leave it for 20 mins then its ok again until the next 30 mins very frustrating
The spindle bearing (tapered bushing) hasn't been properly lubricated / maintained and it is hot seizing.
Single phase or three phase?
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.