Ikegai Fanuc 10 TF _ E95 C Ram parity Error

Sep 04, 2006 1 Replies
A

Hi All, I have an Ikegai CNC Lathe fitted with Fanuc 10TF, When we turned on the machine a couple of days back, as soon as the control powers up it shows: E95 C ram parity Error. No further action is taken and the control hangs. We are able to see our old Part programs. We can see the postion screen but not able to run the program. The main board has 1 displayed on it this means the NC has no problem can it be the BATTERY issue. Should we replace the battery. Any one can help me with the parameters, i got advice that Parameters are lost.



Best regards, Govind



Vote
Twitter Facebook LinkedIn
G

I think your ram is corrupt. I hope you have a backup of the parameters cause I suspect you are going to have to do a full reset..at which point the parameters are POOF'ed and will need to be reloaded. Often a low battery will allow the ram to not refresh right, or hold all addresses and then..Crunch..bad s*it happens.

Gunner

"I think this is because of your belief in biological Marxism. As a genetic communist you feel that noticing behavioural patterns relating to race would cause a conflict with your belief in biological Marxism." Big Pete, famous Usenet Racist

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required