looking for feedback on Raytech Tumble Vibe 5

I am considering purchasing Raytech's Tumble Vibe 5... looks like a safe buy, as it is quite popular. I currently have a 3 CU ft machine using 3/8 cone plastic media with a flow thru soap set-up, and also a small Lorton 8" rotary tumbler which uses a mix of water and media. My question is, what type of media can be used in the little tumble vibe 5? I am polishing zinc die cast parts looking to basically remove the flashing, and also removing end mill marks on aluminum jigs I have been producing in small quantity. Being Saturday, I can't get anyone on the phone until Monday (at Raytech) and I am going out of town Sunday night, so I figured posing this question to the group may answer my question before Monday, and I can just fax in my order before leaving.

Thanks in advance,

Ryan

Reply to
Ryan
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.