1. Home
  2. ⏣ General Metalworking
  3. MEW in Oz

MEW in Oz

I've got a few doubles of Model Engineers' Workshop magazine: 57, 79 and 99.
Anyone in Australia got any of these issues, to swap?
1 to 41
44 to 52
54
58 to 60
65
69 to 78
80 to 84
86
93
Jordan
Reply to
Jordan
Loading thread data ...

Further Reading

  • Model Engineers Workshop No27

  • Hi all I am looking to buy the Model Engineers Workshop edition no27. Thiswill...

  • ? publishers "Model Engineers Workshop"

  • Goedendag ;-)I'm trying to find the publishers (and their site) of the...

  • Model engineers workshop

  • Hi I am looking for a copy of issue No2 Autum 1990 M.E.W. to compleate my...

  • Back issue of Model Engineers' Workshop

  • KenI've also found TEE publising very good but you could try this link...

  • Model Engineers Workshop Magazines (Swap)

  • I have the following Model Engineers Workshop Magazines to swap.Mgazines spare...

  • Model Engineers Workshop 102

  • I did not renew my subscripton with them,one of the reasons was thaabout half...

  • "Machinists Workshop" Worth it?

  • Howdy! The US subscription to Model Engineers' Workshop is 26.5 poundswhich...

  • Model Engineers Workshop No 50

  • One of my friends who does not have Internet access has asked if anyonehas the...

  • Model engineers Workshop magazine digital edition

  • anyone else having trouble accessing the mag on-line? I'm paid upuntil end...

  • Number of Model Engineers in the UK?

  • Hiya,Does anyone have a round number for Model Engineers (with a Railway bent)...

  • Home brew plastic injection molding - Model Engineers Workshop Magazine

  • Hi,Issue 92 August/September (I think) of UK based Model Engineers...

  • MEW- Setting up a Workshop Special

  • Anyone else had trouble getting their copy?I ordered one online at the new...

  • Following on from 'Rust in Workshop'

  • Hi all.Thanks for all the replies about rust in my workshop. I'll have a...

  • Flashback arrestors in Oz

  • Last time I was in BOC, I was pointed to a (verymall and tight downnear the...

  • Pinging Alan in Oz

  • Hi Alan, My mate here in the UK is emigrating to Perth in the next few months,...

  • Monarch Table Saw

  • I've inherited a table saw, all cast iron with the name Monarch cast into the...
  • « previous thread

  • What is it? CXCVII

  • The latest set has just been posted: Rob What is it? 1085 Superegg (ellipsoid...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.